Can I use my cell phone charger that fits into the iRiver player?

IRiver H Series players use a battery charger that converts AC Line Voltage(100-240 VAC @ 50-60HZ) into 5 VDC at 2 Amps. However the polarity of this charger is not always the same as phone chargers. IRiver players need to have a charger that is wired to make the center conductor positive and the outer conductor negative.

If your phone charger is not wired to operate like that and you do use it your player will turn into an expensive brick…..absolutely 100% for sure! No if’s and’s or but’s! To make sure your phone charger is wired correctly you should attach it to a volt ohm meter and measure both the voltage and polarity it of this voltage.

If the voltage and polarity are the same as iRiver but the current is a little low do not worry…..it will work. See the symbol below to refer how the battery charger needs to be wired. Again, if your phone\PAD charger is not wired exactly the same as your iRiver player DO NOT attempt to use it as a charger for your DAP.

It will go pear-shaped and ... more.

I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.