Hi, I need to wall paper where there are 2 wall lights, what is the best way to "blank them off"?

Similar questions: wall paper lights blank.

I'm not sure I understand your question here.

Take off the fixtures. Cap the wires (with plastic wire caps). Make sure these are tight.

Buy some metal plates that fit over the boxes that held the fixtures. Install and screw them in tightly. Paper or paint over.

What elbandito recommended is illegal. You have two options: you can disconnect the wiring going to the lights completely, and remove it from the wall if possible. THEN repair the wall where they were; OR you can buy covers intended to give a finished appearance; remove the lights, and then use wallpaper on the covers the same way you would use it to cover switch and outlet covers - but those covers must be removable.

Or if what you mean is, what is the best way to remove them for wallpapering and then replace them; simply remove the lights and "safe" the ends of the wires with wire nuts, then wallpaper the wall, and cut the paper clear of the mounting boxes, and reinstall the lights.

What is the history of big box home improvement stores in Michigan.

I'm looking for a home improvement / DIY group on usenet.

I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.