How can I put the LM629 back into normal operating mode after an "excessive error" interrupt has been tripped?

There are two possible approaches to get the motor moving again after using the RSTI command (see command set for usage) to reset the excessive position error flag. (1) Reset the particular device with RST command, depending on how this may affect your application. (2) Read the current position of the stopped motor using the RDRP command.

Use the read position as your new destination position. Start the motor (STT command). More.

I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.