How do I convert a PSpice model for use in B2 Spice?

A specific PSPICE specific conversion to look for is how PSPICE denotes resistors, capacitors, and inductors in the . Model line. PSPICE uses RES, CAP, and IND where Berkeley SPICE uses R, C, and L respectively.

For instance, a resistor model in PSPICE will be something like . Model rmod RES ... whereas Berkeley SPICE will look like . Model rmod R ... Also, PSPICE's dependent sources can use a VALUE= syntax and then an equation for the voltage or current.

SPICE doesn't have this syntax but the conversion for this is to replace the device with a non-linear source, depending on the original PSPICE device type. For instance: PSPICE: EFB 12 OUT VALUE={8.822-.4024*V(13,5)+5.250E-3*V(13,5)*V(13,5) -.6667*V(13,5)*V(6,5)} SPICE: BEFB 12 OUT V = 8.822-.4024*V(13,5)+5.250E-3*V(13,5)*V(13,5) -.6667*V(13,5)*V(6,5) The "VALUE =" with a "V=" to denote a voltage source because the original device was an "E" voltage controlled voltage source and the "V =" means "voltage equals". If the original device ... more.

I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.