How do you adjust the forward pressure setting on Fritschi bindings?

First do a rough adjustment of length so that your boot snaps in and looks like it's correctly held (if possible, use boot sole length in millimeters and set binding to corresponding number that shows on rail just behind heel unit.) Length adjustment is done with the screw at back end of the binding rail. Next, with the boot in the binding, adjust the length screw a few turns in or out so that it's exactly flush with the rear surface of the rail. Take care to get this right.

Too much forward pressure may cause the toe unit to break off the binding, while too little will cause pre-release. More.

I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.