How Do You Mod A Nerf Gun?

A Nerf gun is designed to imitate the firepower of real weapons while providing a safe experience through soft projectiles that can not hurt anyone. You can modify, or “mod,� A Nerf Nightfinder gun so that the projectiles will hurl from the gun with greater force.

You will need to partially disassemble the Nerf Nightfinder, voiding any return warranty that might be in place. Ask for help from an adult if you are underage since you must use a cutting tool to modify the Nerf Nightfinder. Place the Nerf Nightfinder on a table with the barrel facing to the right.

Remove all of the screws from the Nerf Nightfinder with the Phillips screwdriver in the following order: The screws from the top left, right and middle edge; the screws surrounding the trigger guard; the screw at the back edge below the pull-out rod; the screws from the handle; the screws at the front of the barrel; and the screws from the top and bottom of the flashlight plate directly beneath the barrel. Pull the top cover ... more.

The Nerf-brand Maverick pistol shoots foam darts in rapid succession, thanks to the large capacity of its magazine barrel. Because the revolving barrel cannot swing out of the Maverick's frame, reloading is a slow and laborious process. You can modify, or "mod," the Maverick so that the barrel swings out in a similar fashion to that of a real pistol.

The procedure is straightforward and requires a few tools commonly found around the house. Place the Nerf-brand Maverick pistol horizontally on a table with the handle on the left side. Pull out the cocking lever to the left of the hammer until it locks.

Remove the screws from the handle with the Phillips screwdriver. Remove the screws from in front of the trigger guard and at the lower front edge with the Phillips screwdriver. Remove the screws from the top front edge and on the top of the Maverick above the trigger guard.

Remove the screws from above and below the hammer on the left side of the Maverick with the Phillips screwdriver. ... more.

The Nerf brand Recon pistol fires foam darts that are designed to be safe if they hit someone. The Recon has been crippled by the manufacturer to decrease the amount of air pressure generated when fired. Modifying, or "modding," the Recon will enable a foam dart to travel for a much greater distance.

You will need to disassemble the Recon in order to mod it--voiding any warranty that might be in place. The modification only requires a few common household tools. Place a soft cloth on a table.

Place the Recon on the soft cloth with the barrel facing to the right. Remove the screw from beneath the tip of the barrel with the Phillips screwdriver. Remove the screw across from the screw beneath the barrel.

Remove the two screws from the top front and back edge of the Recon with the Phillips screwdriver. Remove the screws around the trigger guard. Remove the screws from the back and bottom edge of the handle.

Remove the screw from the back edge beneath the hammer. Pull the sliding plate at ... more.

I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.