How Do You Mount Telemark Ski Bindings?

You can mount your own telemark bindings at home with the proper tools. All you'll need are a drill, drill bits, a ruler, epoxy and a felt-tip pen. Find the midpoint of your skis and telemark boots.

Both should be marked by the manufacturer; otherwise, measure the halfway point of each with a ruler. Place the loose toe plate of one binding onto a boot and secure the two together. Place the midpoint of the boot with the binding attached on top of the midpoint of a ski.

Hold the binding steady, and use a felt-tip pen to mark the screw hole spots onto the ski. Take the boot and binding off, and use a ruler to make sure the marks are centered along the width of the ski. Find a drill bit that has a diameter of about 3/64 inch smaller than the binding screw.

This will allow the screw to bite into the ski when screwed in. Drill into the ski on the marks, making sure to drill only halfway through the ski. Fill the holes with epoxy or a similar adhesive, and quickly screw the toe piece of the ... more.

I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.