Similar questions: 1997 Ford Contour stalling lights stops won't start ideas.
Ill give it a try, but no guarantees Check your pulley belts and battery...you never know. I fried a battery and almost my engine because I had a pulley that was broke and didn't know about it. AF ratio might be a concern here...try changing the fuel filter (probably no help but good practice) and your air filter.
Perhaps check the spark plugs and make sure the integrity of the distributer cap is sound. If none of those are it then its either the engine or fuel line. Maybe its a pump for the fuel line or it needs a flush.
If thats not it make sure your engine has compression, if not then there is the problem. Anything other than that im not sure what it is.
1 Lousy workmanship. Ford Contours are disasters! This user has been banned from Askville.
1 Lousy workmanship. Ford Contours are disasters! .
Lousy workmanship. Ford Contours are disasters!
2 Now, now, the car did run at some time. Common problems are clogged injectors, weak fuel pump, clogged air filter, clogged fuel filter, slipped timing belt. You probably need to take it or get it towed to a service place.
Now, now, the car did run at some time. Common problems are clogged injectors, weak fuel pump, clogged air filter, clogged fuel filter, slipped timing belt. You probably need to take it or get it towed to a service place.
3 It's probably not the fuel pump. Low fuel pressure tends to cause problems when driving, not when stopping. Could be the EGR valve or injector problems, as A_H mentions.As I recall, that model has a single TB injector.
Your car is post OBDII, so any repair shop should have a scanner that can read out the DTCs and tell you what the problem is.
It's probably not the fuel pump. Low fuel pressure tends to cause problems when driving, not when stopping. Could be the EGR valve or injector problems, as A_H mentions.As I recall, that model has a single TB injector.
Your car is post OBDII, so any repair shop should have a scanner that can read out the DTCs and tell you what the problem is.
5 Like I said, get your codes read. If you could get the car to run, a lit-up MIL would tell you something is wrong, but it isn't running. It could be anything from the distributor to a timing belt.
Like I said, get your codes read. If you could get the car to run, a lit-up MIL would tell you something is wrong, but it isn't running. It could be anything from the distributor to a timing belt.
My 1998 ford expedition won't start, I her a clicking noise down by the fuse panel,when it clicks my inside lights blink. " "Where is the fuel pump relay located on a 1997 Ford Contour? " "i have a ford excursion it won't start after six months and the injecter is not pulsesating" "Where is the ground connection for the dash lights on a 1997 Ford Thunderbird?" "My dodge ram 1500 1997 won't start.
Check relys there good. Changed fuel pump engine cracks but won't start. Help" "My macbook has a gray screen and it won't go away and it won't start up.
I have tried everything! My caps lights up tho.
My 1998 ford expedition won't start, I her a clicking noise down by the fuse panel,when it clicks my inside lights blink.
I have a ford excursion it won't start after six months and the injecter is not pulsesating.
My dodge ram 1500 1997 won't start. Check relys there good. Changed fuel pump engine cracks but won't start.Help.
My macbook has a gray screen and it won't go away and it won't start up. I have tried everything! My caps lights up tho.
I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.