TeamCity synchronized Build Step or wait for a step to finish?

All your steps will be performed in turn, so somehow your previous steps seem to signal that they are ready before the output is written.

Up vote 0 down vote favorite share g+ share fb share tw.

Currently I have FxCop and Nunit with dotCover setup and would like to copy all temp files used in the build to another location at the end. The problem I am having is that the last commandline step that does the xcopy runs before NUnit/dotCover is completed and temp files are produced. Any comments?

Thanks, teamcity link|improve this question asked May 24 '11 at 22:47Eatdoku7202924 59% accept rate.

All your steps will be performed in turn, so somehow your previous steps seem to signal that they are ready before the output is written. We use NAnt to make a "sleep" call for 10-15 seconds in some of our configurations, after a deploy for instance. Try that and see if it helps.

I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.

Related Questions