Can you tile over existing tile?(in kitchen-backsplash)?

Can you tile over existing tile?(in kitchen-backsplash) Asked by Eve 53 months ago Similar questions: tile existing kitchen backsplash Home > Home Improvement.

Similar questions: tile existing kitchen backsplash.

It's possible; here's how: Tile over Tile It is possible, with modern technology, to successfully bond tile to tile. Done properly, a new tiled installation can be placed permanently over an existing tiled installationIf the existing tiled surface is dimensionally stable, has the required expansion joints, and is satisfactorily on-plane, this method can be used. Its desirability, however, rests on the user.

The main drawback to this method is its increases in dimensions and the aesthetic appearance differences. This simply means that the new installation may not fit. For example, if the floor tile is already at a maximum height in a room, it may not be possible to add additional height.

Or, if the existing tile in a tub enclosure is already at the maximum thickness allowed for the wall, this method cannot be used. The aesthetic differences mentioned also include the way the new installation will receive the trim. Generally, the new installation will have to receive some additional trim element in order to be visually appealing.In the case of flooring, it may be necessary to install a threshold to make up for the difference in height.

In the case of wall tile, additional trim elements will need to be used for the same visually appealing reason. Once the decision has been made to use the tile over tile method, the next question deals with what type of bonding agent will be used. Certain types of organic adhesives, Portland cement mortars, and epoxy mortars can be used.

The Manufacturers recommendations should always be used. In the photos below, we see a typical tile over tile installation on a fireplace surround. This choice worked out quite well due to the damaging effect that the removal of the existing tile posed.

The existing tiles were well bonded and structurally sound. The first step in the tile over tile process is thoroughly washing the existing tile to remove any wax, oil, and coatings that would adversely affect a good bond. The next step, which is recommended, is to rough up the surface with a carborundum disk or belt sander.

This step is followed by a fresh water wash to remove the sanding particles . Next a level ledger was installed that will support the upper tiles until they have achieved an initial set. The upper existing tiles received a freshly combed "medium bed" Portland cement mortar bed using a 1/4" x 1/4" notched trowel.

The tiles were back-buttered, placed, beaten in, and aligned properly. In this case, time was not an enemy and the upper tiles were allowed to cure overnight. The next day the lower tiles were installed following the ledger removal.

Later the hearth tiles were set finishing the job. Keep an eye on this section for more jobs involving the tile over tile process. Home | newsletter | terms of service | links | contact | site map Sources: http://www.thetiledoctor.com/repair/tileovertile.cfm .

It is not recommended. The tile cement likes to hold to porous surfaces like concrete and drywall. Most tile is smooth and glazed for easy clean up.

This may cause the cement to fail to stick, especially on a vertical backsplash. Removing tile is a tough and dirty job. It takes hammers and chisles, and debris flies everywhere.

You can even damage your wall if you do it incorrectly. I still recommend removing the tile. Wear eye protection, and tape old towels to hang around the tile to catch the flying debris.

Once the tile is off, your new tile will hold much better. If you don't remove the old tile, the new tile may go on just fine, but will probably start falling off a year or 2 down the road. That would be a lot of wasted effort.

A good tile job should last for decades. You can do it, but it is not recommended. I hope this helps.

Manimal's Recommendations Setting Tile (Fine Homebuilding) Amazon List Price: $19.95 Used from: $6.00 Average Customer Rating: 4.5 out of 5 (based on 30 reviews) .

1 When I retiled our bathroom, they tiled over the existing tile but I don't know if you can do that on a backsplash. They did my bathroom that way because they said it would be better because it was an upstairs bathroom; but otherwise, I think most of the time they take out the old tile.

When I retiled our bathroom, they tiled over the existing tile but I don't know if you can do that on a backsplash. They did my bathroom that way because they said it would be better because it was an upstairs bathroom; but otherwise, I think most of the time they take out the old tile.

" "Home Improvement, Electrical Quesiton - I have 8 recessed can lights in my kitchen. " "what is the best tile to install in a kitchen" "I am looking for tin backsplash,to put behind my stove,I found some at home depot,but it was too much money,where can I" "what type of tile is best for kitchen flooring.

I am remodeling my kitchen and needs some backsplash tile ideas.

Is it recommended to tile over existing wal ltilesein a large area such as a bathorom.

Home Improvement, Electrical Quesiton - I have 8 recessed can lights in my kitchen.

What is the best tile to install in a kitchen.

I am looking for tin backsplash,to put behind my stove,I found some at home depot,but it was too much money,where can I.

What type of tile is best for kitchen flooring.

I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.