How do you remove the governor on a motorized go-cart?
Answer if its a 2-stroke the governer is a little black block that keeps the throttle from opening. So watch the throttle on the carb as you slowly open it. Just remove about half of it though or else the throttle will start to close again.
2Remove the screws from the black plastic cover at the rear of the seat. 3Take off the plastic cover. 4Look straight down where the plastic cover used to be and you will see a spring apparatus connected to the throttle cable.
This is the governor. The spring apparatus will have two nuts, one small nut and one larger nut. 5Loosen the small nut and tighten the larger nut.
The more you tighten the the larger nut, the faster your cart will go. 6After you are satisfied with how fast your cart goes, tighten the small nut back up. 7Replace the black cover.
I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.
Related Questions
Do you have to change the oil in a motorized go cart?
Where is a good place to find Golf Cart Parts and Golf Cart Accessories?
How secure will my cart be when towed using the Trash Cart Hitch?
When was Governor Mike F. Easley first elected to the office of governor?
Who is the Governor and lieutenant governor of Texas?
Who is the Governor and Lt Governor of Texas?