How do you replace a head light bulb on a 1997 Toyota Rav4?

Answer fIRST YOU SEE A RUBBER GASKET SURROUNDING THE HEADLIGHT PLUG IN THE BACK OF THE HEADLIGHT ASSEMBLY. PULL OFF THE GASKET AND LET IT HANG ON THE SURROUN DING HEADLIGHT WIRES. THEN PULL OFF THE HEADLIGHT WIRE HARNESS BY GRABBING THE SOCKET (NOT THE WIRES).

AROUND THE BULB IS A THIN SILVER HOLDING SPRING THAT LOOSENS BY SQUEEZING THE ENDS TOGETHER AND ROTATING IT. IT WILL LOOSEN AROUND THE HEADLIGHT. WHEN THIS HAPPENS THE HEADLIGHT WILL "FLOP" AROUND AND PULL IT OUT, REMEMBERING TO SEE HOW THE THREE CONNECTORS ARE LOCATED (I.

E - IS ONE CONNECTOR AT 12 O CLOCK POSITION AND THE OTHER TWO ARE AT 9 AND 3 OR ARE THEY AT 3,6 AND 9, ETC. ). RE-ASSEMBLY IS THE OPPOSITIE.

THE TRICK IS TO GET THE THIN SPRING WIRE BACK IN PLACE. YOU HAVE TO SQUEEZE THE SPRING AND RE-POSITION IT SO IT KEEPS THE BULB SECURLY IN PLACE Having just changed the bulb, I would advise taking the whole headlight assembly out first. It is near impossible to feel or imagine how to change the bulb without seeing it.

First, use a Phillips screwdriver to take the single screw holding the strip off just below the headlight assembly. By doing so, you will now see the other two bottom bolts holding the headlight in. Take all four bolts out then disconnect the bulb from behind.

Then proceed as above.

I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.