I have bought an "A4983 Stepper Motor Driver" can I use a 100K resistor before the step pin?

Full answer: Try it and see, worst case senario, (assuming you are using sane voltages) is that it won't work, or won't work reliably. Chances are, it will work at slow speeds(The input is TTL compatible, so why not just drive it directly with a micro?

I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.