If you replaced both cv's and now the car shudders on acceleration then replaced both again and still same thing what could be the problem?

If so, an incorrect fluid type may have been put into the trans after replacing the axles causing a shudder. Check all motor/trans mounts.It needs a front end alignment, you move the setting when youchenged the cvjoints. Cvs should not make car shudder on acceleration I would try wheel alignment, and check drive shaft U-joints Poor or low quality axles - like you might buy at Checker or O'Reiley can sometimes cause this sort of shudder or vibration.

I have never had this issue when using OEM parts, however they are much more costly.

I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.