Where can I find a male mate to the female 4 pin connector found on mini/board/pinhole cameras so that I can build an RCA/audio/power cable?

I'd go for a free sample from Molex. Just make sure to check the pitch and make sure that it looks like it would mate properly (look at the mechanical drawings from Molex). Remember you'll need the crimp receptacle as well the crimp terminals (and a way to crimp the wires to the terminals).

Hope this helps.

Alternatively you could just solder a new 4 pin connector onto the board or just solder the wires directly.

I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.