How Do You Install Seymour Duncan SH-6N Distortion Blk Pickups?

If you love your guitar but you just cannot seem to get the proper distortion out of it, it may be time to change the pickups. And if you are changing the pickups, you may as well use some of the best in Seymour Duncan. The SH-6n humbucker can come with or without a metal cover plate, and by following this guide you should have your new pickups in place and ready to shred in no time.

Remove your old strings. Unscrew the back plate on the guitar and remove the cover. Warm up your soldering iron while you get to know the wiring.

Carefully observe the wiring that is in place. The SH-6n is meant to replace the humbucker closest to the neck. There should be one hot cable connected to the volume knob and one connected to the ground on the volume knob.

This second ground should also have a wire in the same spot. When your iron is ready, touch the soldering iron to melt the existing solder to remove these two cables. Unscrew your humbucker and remove it from the body.

Look over the SH-6n ... more.

I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.