How many quarts of oil does a Chevy vortec engine hold?

Changing the oil in your vehicle is simple when you know what to do. … It's more complex than just throwing in a new quart of oil. It's requires an afternoon of getting your hands dirty, but it could save you up to $100.

There are environmental guidelines you need to follow, so be aware of those as well. Try following these steps to make sure you get the job done right.It's important to let your vehicle warm the oil a little before changing it. It will be thinner and quicker to drain if the oil has run through the engine.

If this is the first time changing the oil in this particular vehicle, you might want to look at your owner's manual to make sure there aren't special instructions like the location of the oil pan, drain plug, or oil filter. Then, make sure you have the right tools listed in the manual on hand. First, you will want to wear the proper safety goggles when working under your vehicle.

Oil, grease, or other foreign objects can flake into your eyes if they're not properly protected. *b) Grab a BucketYou'll need a pan or a shallow bucket to catch the old oil. It will need to be shallow enough to fit under the vehicle, but large enough to hold about five quarts of oil.

Put it in place under your vehicle. *c) Loosen the Drain PlugYou'll turn the oil plug counter clockwise using a wrench to loosen and release it. Gravity will help drain the oil.

Make sure the bucket or pan is in place before you release the plug. If you lose the plug during the draining process, a magnet might be able to help you find it easily and without digging through dirty oil. Your owner's manual will help you locate the oil filter on your vehicle.

These are usually located in different areas depending on the make, model, and year of the vehicle. Most manufacturers suggest you replace your oil filter every time you change the oil. This helps keep your engine running smoothly.

There will be instructions on how to remove and replace your particular vehicle's oil filter in the owner's manual. Replace your drain plug with a new gasket or washer and make sure it's tightened. There's no need to over tighten the plug.

This will keep the new oil sealed and ready for use. Your owner's manual will hold the key to knowing which type of oil your vehicle needs to run its best and how much to use. Most vehicles take between four and six quarts of oil.

Whatever you do, don't wing this one. Look for the answers in your owner's manual to be sure. Putting in too much or too little oil could seriously damage your vehicle.

Now, it's time to replace the fill cap under the hood and begin your cleanup. Make sure you retrieve any tools that may be under your vehicle. You don't want to accidentally run over a wayward tool and puncture a tire.It's finally time to start your engine and let it run for a few minutes.

This allows the new oil to begin circulating through your engine. This one last step will make sure you're good to go. Check the oil after your vehicle has cooled down.

Make sure you're sitting on a level surface so your car's dipstick can accurately read the amount of oil in the reservoir. The first thing in the morning is a great time to do this. If your dipstick is reading low, you might want to add another quart of oil.

You could be fined by the Environmental Protection Agency (EPA) if you don't dispose of used motor oil properly. It's not something you can bury, throw away, or pour down the drain. Doing any of those things can and will pollute the local water supply.