How to build a hoverboard?

To build a hoverboard, start by cutting a 48 inch diameter disk out of plywood. Cut a hole in the center of the board just large enough to fit the head of a leaf blower into. Next place the disk on top of a 6' by 6' sheet of plastic, then fold the edges of the plastic over the board, staple about 4 inches apart, and seal the edges with duct tape.

Turn the contraption over and screw a coffee can lid to the center of the bottom of the board, then cut 6 vent holes around the edges of the lid. Turn your hoverboard back upright, insert your leaf blower into the hole and turn it on to fill the plastic bottom with air to float your board. More.

I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.