Why would the gain go up in a circuit board when you put an emitter capacitor in the circuit?

The emitter resistor is there to provide DC bias to the base. If it is not bypassed, then the AC output signal is also dropped across this resistor, effectively lowering the output swing When a bypass capacitor is added, the DC bias still flows through the resistor, but the capacitor acts as a short circuit for the AC signal, so that the AC signal is not reduced. The capacitor selected must be large enough so it appears as a very low resistance at the lowest frequency the amplifier will pass.

I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.