Answer 1 This is usually caused by a bad thermocouple. The thermocouple looks like a thick, solid copper wire screwed into the gas valve on the water heater. The pilot flame heats the tip of the thermocouple, causing it to generate a minute electrical current at low voltage, which provides power to an electric valve that controls the flow of gas to the main burner.
If you attempt to relight the pilot burner and it refuses to stay lit when you release the button on the gas valve a minute, or so, after the flame has been lit, the thermocouple is the most likely cause. Replacement thermocouples are readily available from most hardware stores and can be replaced by the homeowner, using simple tools, by following the instructions on the package Another cause of the problem could be a lack of air to the combustion chamber. Newer water heaters require more volume of air due to the addition of a heat sensitive diode to the thermo coupler.
Not enough air flowing through the combustion chamber to carry the heat up through the flue causes heat build up, which kills the thermo coupler. On my water heater, I could light the pilot and the water heater would burn for 20 minutes or so and shut off. The fix included routing the flue straight through the roof and opening floor to allow more air into the water heater compartment Answer 2 Another possible culprit may be waterheater vent height above the roof.In some situations this may periodically result in a downdraft situation that could cause the pilot light to go out.
If this is the case adding to the vent height may help. Note: building code states that the B vent required height is based on the roof pitch but it must be 2' highter than any portion of the building within 8' of the vent Answer 3 make sure the vent cap isn't missing or rusted through on the roof, it will cause drafts and wind to blow out the pilot.
Constantly working pilot light is essential for the operation of a gas water heater and here are a few of the most common issues that cause the pilot light to go out. Be sure to shut off gas supply before attempting to troubleshoot or repair any part of the water heater! If you are not comfortable working with gas, please call a professional.
If you smell gas at any point in trying to find the problem, do not light the pilot. Repair the gas leak or call your utility company first! 6. Main burner partially clogged and causes a blow back which blows out the pilot.
Condensation or small leak in the tank causing water to drip on the pilot light. Thermocouple is a device that consists of two joint wires made of dissimilar alloys that produces slight voltage proportional to the temperature difference between the hot and the cold ends. It is used in the heater to sense the presence of the pilot flame.
If the flame goes out, the thermocouple cools off and the gas valve which it is connected to, shuts the gas? A safety feature. Thermocouples are arguably the most common cause of water heater pilot light going out either immediately or shortly after being lit.
The thermocouples are constantly inside a flame, they can literally burn out in a few years and need replacement. These are an inexpensive part (less than $10) and are easy to install for a DIY homeowner.
I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.