So we can take shower w/o a leak... The run over valve is leaking into the basement. We rent and for two days are landlord has avoided our calls. I thought I shut off the main water to the water heater but water is still going to places in the house except basement shower.
Asked by bam77 29 months ago Similar questions: shut hot water valve leave cold shower leak Home > Home Improvement.
Similar questions: shut hot water valve leave cold shower leak.
Cold water valve on too They pulled a big hose into the house and hooked it up to the hot water line. The idea was to blow air through the system and listen for leaks. Victor used what I can only describe as a plumber's stethoscope.It's like a normal stethoscope except that instead of a little metallic disc on the end, it actually has two long rubber tubes with larger discs on their ends.
He puts them on the floor and listens to pinpoint the leak. I should have taken a picture, but well... it was early. Anyway, the good news is that he found the problem.
The bad news is that there are multiple leaks, which means the galvanized pipe is likely shot. Rather than jackhammer into the floor and patch them up, the real solution appears to be re-plumbing the house to bypass the degrading galvanized crap. Sources: jeremy.zawodny.com/blog/archives/004028.... .
So we can take shower w/o a le Unfortunately, my research indicates that the timers are only available for electric water heaters. It makes sense though, considering how they work. If a device that did the same type of thing for a gas water heater was available, it would probably end up costing about as much as a new water heater, only because you would most likely need to have it professionally installed.
Gas pipes would need to be cut & re-attached etc. For more information & some tips on how to save energy & money, you can look at this site. Also, check out the items below. People have told me that they have saved a lot using one.
Sources: askville.amazon.com/install-timer-GAS-wa... .
Shut hot water valve off and leave the cold water valve on too The shut off valve on the hot water side under the sink will not totally close but there is only a small drip (not from the stem but out of the top of the valve. I live in a condo setting and so it is a big ordeal to change the valve. I would like to replace the sink and use the same faucet.My question is if I leave the supply line for the hot side connected to the valve end and buy a fitting to plug it wouln't this work?
I can then take my time and connect the faucet and new supply lines, garbage disposer etc before dropping in the new sink. Am I nuts or will this work or has anyone another suggestion Sources: bobvila.com/wwwboard/messages/280333.html .
Solutions on water valve at askmehelpdesk.com. You don't need to drain the hot water tank, only make sure water is free to flow in and out either the inlet or outlet. Normally that is taken care of by the inlet, but will not be if you manage to shut the main valve off.
If you have a stop under the sink, or a shut off on the hot water tank, you can leave the main valve on, allowing water to flow in and out of it, and shut the hot water off after the tank just as in normal use. If you have to shut off the main valve which doesn't sound like will work, or a valve on the inlet, then turn the gas to pilot or shut the electricity off to the tank. Leave a hot water tap open somewhere so water can flow in and out of the tank.
When you are done, close the hot water tap you left open, and immediately open the cold water you shut off. Open a hot water tap to allow any air that worked its way in out again. When the tank is full and has the cold water line open, turn the gas or electricity back on.
Remember, either the inlet or the outlet and a tap must be open at all times. Water expands and contracts with temperature changes. It has to go somewhere.
Sources: http://askmehelpdesk.com/plumbing/how-shut-off-hot-water-water-house-48001. Html .
This sounds like a question to ask MOEN directly. Here is where to find your answer:" Yes. You can shut hot water valve off and leave the cold water valve on too?
So we can take shower w/o a leak. Call: 1-800-BUY-MOEN (1-800-289-6636)8:00 am to 8:00 pm Monday thru Friday8:00 am to 6:30 pm on Saturdays ESTClosed on Sundays and all nationally observed holidays. To contact Moen Canada call: 905-829-3400 While the valves do have several similarities: * A pressure-balanced system that maintains water temperature within ±3°F (1°C) * Built-in temperature limit stops which allow you to control how far the handle rotates, therefore, controlling the range of water temperature * Best water flow for any comparatively priced valve * Available in a variety of connections from common ½" CC/sweat, ½" IPS-threaded; ½" PEX or CPVC * Meets pressure-balancing safety codes There are a few differences to consider before making a decision.
Moentrol® Posi-Temp®Handle Operation - – how the faucet is turned-on and off. Pull / Push RotationTemperature memory - When shutting-off the faucet, the handle stays in the exact temperature position you set during use. The next time you turn-on the faucet, within a few seconds, the water temperature reaches your last temperature setting.
Yes NoVolume Control - Controls the water flow rate so you get the amount of water you want at the temperature you want. Yes NoFlow Out of Unrestricted Tub Spout - the gallons per minute of water flow through the tub spout. 7.5 gpm 6.3 gpm o not use cleaners that contain abrasives, harsh chemicals, alcohol, or other organic solvents.
Avoid using any cleansers or pads/sponges that are unsafe for polished metallic surfaces. Most green, fibrous pads/sponges contain microscopic mineral particles that can scratch a faucet's finish. Cleaner manufacturers may change their formulations at any time; therefore, Moen does not recommend any specific cleaner.
Immediately after cleaning your faucet, wash off remaining cleaner with water. To remove water spots, use warm water and a soft, damp cloth. Hard water stains can be removed with a 50/50 solution of white vinegar and water, followed by rinsing with water.To preserve the luster of your faucet, occasionally apply a high quality non-abrasive wax, such as car wax or furniture polish.
For faucets with clear knob style handles, cleaners should be approved for acrylics. Sources: http://www.moen.com/consumersupport/FAQs/ .
My hot water won't turn off in my bathtub. I have three nobs- one for hot, cold and to turn on the shower. " "I get pretty consistent hot water out of the shower head, but the tub starts hot and gets cold.
What could it be? " "My bathroom sink water is scalding hot, but my shower hot water only gets lukewarm...what's the problem? " "when bleach water is used as a sanitizer, should it be used in hot water or cold water?" "Which is better for getting rid of germs.
Hot water or cold water? " "The hot water faucet in my bathtub won't shut off the hot water flow. What do I do to fix the problem?
" "which has more humidity hot or cold water? " "Does hot water freeze faster than cold water?" "my hot water went cold, is it because of the fuse? " "were is the valve that conyrols hot and cold water in the tub.
My hot water won't turn off in my bathtub. I have three nobs- one for hot, cold and to turn on the shower.
I get pretty consistent hot water out of the shower head, but the tub starts hot and gets cold. What could it be?
Which is better for getting rid of germs. Hot water or cold water?
The hot water faucet in my bathtub won't shut off the hot water flow. What do I do to fix the problem?
Were is the valve that conyrols hot and cold water in the tub.
I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.