How do you replace a driver's side speaker on 1997 Toyota Camry?

Br />this cruthfeild website is only an ad page --> go to www.cruthfeild.com you can get install info and buy new speakers If you don't know how to remove the inside door panel, this link is very helpful:http://autorepair.about.com/od/otherodddiyjobs/l/aa092504a.htm.In addition to the advice at the above site, I found another trick to removing the trim around the inside door handle. The above article refers to putting a screwdriver UNDER the door handle and pushing down ... to release a "secret latch". That's the first step.

The second step (which is not in the article) is to insert the scredriver ABOVE the door handle ... vertically above the spot in the above article. Then gently press the screwdriver handle down. With the screwdriver acting as a lever, the tip of the screwdriver will push UP on the top part of the trim.

That will lift the trim up off a small pin on the handle mechanism. With both the bottom and top of the trim piece now "unlatched", slide the trim toward the back of the car, while you open the inside door handle (as mentioned in the article). The trim will come right off.

Be sure to slide the trim toward the back of the car, as you move the trim away from the door panel. (There is a "hooked" piece of plastic on the back of that trim that prevents you from just pulling it out perpendicular to the door panel.) 'Hope these fine points help.PS. My 1996 Camry had 2 screws on the bottom of the door that also were holding the interior door panel in place.

That wasn�t in the article.

This cruthfeild website is only an ad page --> go to www.cruthfeild.com you can get install info and buy new speakers If you don't know how to remove the inside door panel, this link is very helpful:http://autorepair.about.com/od/otherodddiyjobs/l/aa092504a.htm.In addition to the advice at the above site, I found another trick to removing the trim around the inside door handle. The above article refers to putting a screwdriver UNDER the door handle and pushing down ... to release a "secret latch". That's the first step.

The second step (which is not in the article) is to insert the scredriver ABOVE the door handle ... vertically above the spot in the above article. Then gently press the screwdriver handle down. With the screwdriver acting as a lever, the tip of the screwdriver will push UP on the top part of the trim.

That will lift the trim up off a small pin on the handle mechanism. With both the bottom and top of the trim piece now "unlatched", slide the trim toward the back of the car, while you open the inside door handle (as mentioned in the article). The trim will come right off.

Be sure to slide the trim toward the back of the car, as you move the trim away from the door panel. (There is a "hooked" piece of plastic on the back of that trim that prevents you from just pulling it out perpendicular to the door panel.) 'Hope these fine points help.PS. My 1996 Camry had 2 screws on the bottom of the door that also were holding the interior door panel in place.

That wasn? T in the article.

I cant really gove you an answer,but what I can give you is a way to a solution, that is you have to find the anglde that you relate to or peaks your interest. A good paper is one that people get drawn into because it reaches them ln some way.As for me WW11 to me, I think of the holocaust and the effect it had on the survivors, their families and those who stood by and did nothing until it was too late.